A Review Of winchester 748 powder uses

A Review Of winchester 748 powder uses

Blog Article

By subscribing you conform to our privacy plan and would be the to start with to learn about promotions, special provides and product releases.



Really don't understand about 410, but, I bumped into exactly the same detail with Alliant e3. I begun shooting it in .forty S&W and also despatched examination loads to Alliant for force screening with very good effects.

This can be kinda "Superior reloading 101" and can be done when you have a grasp of what is going on at the start degree.

You can find not published load data accessible for this powder for anything at all besides shotguns. According to powder burn up charge charts it is extremely near to 2400. Has anybody had any working experience with this powder beyond loading shotgun shells?

I concur, Never run off reaming anything until you have loaded enough for being self-assured in your stack height.

I ended up installing a plastic powder baffle to reduce similar. I hold a can of bottled air helpful to assist keep down buildup at the base when reloading.




I get 1300 fps from my H110 and like metallic cartridges It appears to carry out greater with the higher speeds. Lil Gun is effective but some say it decreases the hull existence due to burning the finishes in the hull

If This is often your to start with check out, you should definitely look into the FAQ by clicking the connection earlier mentioned. You could have to register prior to deciding to can write-up: click the register link above to move forward.

Now On the flip side, Click Here if the hulls are HS, then the powder bushing you desire should have an ID of .296" in addition to a goal fat fall of sixteen.9grs, which should place the shell all over 1325fps, and which will pattern a hell of large amount a lot better than a person at 1200fps isntead.

I've yet to try 300MP, but from all experiences it is a high-quality 410 powder. I moved to W-296/H-one hundred ten numerous yrs back, for the same causes that Bob states. Higher velocities with reduced pressures. It addresses this subject nicely, and with Superb situation daily life.

So the moment I figured this out, I seperated many of the shells from smallest to tallest. I load the compact ones perfectly. I take advantage of Alliant Green Dot powder with minor to no difficulties. So now I'll do the novice detail and hyjack this thread by using a connected problem for any person with information or reply.

I just utilized my final pound of Alliant 2400. The only thing that I can discover offered which includes any semblance of a sluggish burning pistol powder is Alliant 410.




Although I haven't tried using it click for more I concur with your imagining on a four ball load, sounds like exactly the same difficulty as I Earlier pointed out which has a 5 pellet load of OOO buck.

If The main reason that you will be swapping powders is due to migration trouble on the fantastic ball powder which makes it way earlier the seal and clogging the device, John and I have think of powder style seals that correct the issues from the PW machines, and the design is often converted around on the Spolar machines in addition.